The new two components plug (DUOTEC) made of nylon: The red-grey toggle element made of glass fibre reinforced plastic is suitable for high tension loads in all board materials off a thickness of 9,5 mm. This effects a clearly higher load intake and distribution of loads than conventional plastic solutions.
The red and hard component of the toggle element distributes high loads over the entire seating. The grey, smooth component increases the bearing capacity additionally. It nuzzles on the panel surface and prevents a cutting of the plug and therefore a attenuation of the panel bearing capacity.
The fischer DUOTEC is suitable for fixings with pre-positioned installation in all board materials, as for example in gypsum plasterboard, gypsum fibreboard, timber boards such as OBS, chipboards and MDF-plywood boards, as well as steelplates or plastic plates. Thereby, it can take higher loads without damaging the gypsum plasterboard, differently from conventional toggle plugs.
The new fischer DUOTEC has a diameter of ten millimetre. The small drill hole diameter allows the production of a drill hole with a common 10-mm-drill-bit. The short toggle element is 39 millimetre and simplifies the installation in narrow and insulated cavities off a minimum size of 50 millimetre through its small length.
Information about the DUOTEC