With the new ETA assessment for Option 1 the tension loads are increased up to 10% and the shear loads up to 17%. So fewer and smaller anchors are required.
The minimum embedment depth (see example) makes considerably shorter drill hole depths possible, thus provides a noticeably faster installation and less rebar hits.
The new cup nut, not only gives the option for a better and refined optical design but also, ensures an accident free installation.
FAZ II 6: First bolt anchor with drill-hole diameter 6 mm and ETA Option 1 worldwide, for safe and approved anchorage.
New: Variable embedment depths
Enables most accurate adaption on the loads (M 8 - M 16).
Maximum load with maximum embedment depth FAZ II 10 A4 60 mm embedment depth = maximum permissible tension load of 6.2 kN and shear load of 15.1 kN.
Permissible loads may be calculated for embedment depth between 40 mm and 60 mm.
Fast installation thanks to minimum embedment depth FAZ II 10 A4 40mm embedment depth = permissible tension load of 4.3 kN and shear load of 11.3 kN.
The distinctive edge holds the expansion clip in position even with reinforcement hits, thus ensuring safe installation.
The interaction of cone and expansion clip significantly increases load-bearing capacity and makes minimum edge distance and axial spacing possible.
With a choice of pre-assembled normal washer or large washer GS and with washer HBS in compliance with wood construction standard DIN 1052 (not pre-assembled).
The protruding hammer-in pin protects the thread from damage during setting.